Re: gEDA-dev: new spcie waveform viewer

[Peter Clifton <pcjc2-at-NOSPAMcam_dot_ac_dot_uk>]

On Mon, 2007-07-30 at 16:53 +0200, Thomas Hoffboll wrote:
> Hello geda-dev team
> 
> First i like to introduce my self, i am a electrical engineering student at the university of Dortmund(germany).
> 
> After some trouble building gwave i choose to create my own version of it.
> 
> The tool is named awave for analog wave viewer. The pre alpha version of it is appended to this mail(hope that appending files is a leagal action.). It is writen using c++ and gtkmm and glade.
> 
> The tool builds using the usual ./con.. make, make.. commands
> 
> To make it run the environment variable "GLADEDATA" has to be set to the path used in --prefix // i hope that should be an easy thing to fix for most of you.
> 
> Requirements are:
>  gtkmm-2.4 (tested with 2.10.9)
>  gthread-2.0(tested with 2.12.11)
>  libglademm-2.4 (tested with 2.6.3)
> and of cause there requirements.(glibmm, c++,cairo...)
> 
> The tool is in development so some must have features are not jet implemented like printing, and ascii spice files.

I've just built and taken a quick cursory look - it very nice!

Just a note for building, I have autoconf 2.61 and automake 1.9.6, and
had to scrub out ./configure autom4te.cache, and re-run aclocal,
autoconf and automake. There were a few warnings about the automake /
autoconf, but otherwise it built fine.

As I've not got any binary spice files handy, would you mind emailing me
a small example?

Thanks,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-dev mailing list
geda-dev@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev