Re: gEDA: gerbv-1.0.1 unexpected install behavior....

[paulr <reichp-at-NOSPAMearthlink_dot_net>]

Thanks, Hamish.  I did indeed choose a non-standard
install path.  Wasn't aware that there was a "dh_install"
command in the auto* scripts, though. Is there a man page
about it somehwere?

Forgot to mention that I installed from a tarball, to an
FC-1 system.


Thanks again for replying.

Paul

////////////////////////////

Hamish Moffatt wrote:
> On Tue, May 03, 2005 at 07:44:13PM -0500, paulr wrote:
> 
>>I finally got around to installing gerbv-1.0.1.  The quality
>>of the graphics and the performance of the tool were quite fine!
>>
>>I did run into a few surprises during the "make install"
>>command....
> 
> 
> FYI, here's the commands used to build the Debian package:
> 
> Build:
> 	./configure --prefix=/usr --enable-exportpng --enable-gtk2
> 	$(MAKE) 
> 
> Install (into a temporary directory):
> 
> 	$(MAKE) install DESTDIR=`pwd`/debian/gerbv
> 	mv debian/gerbv/usr/man debian/gerbv/usr/share
> 
> 	dh_installdocs AUTHORS README TODO doc/*.txt
> 
> (That last line copies over those files listed to /usr/share/doc/gerbv).
> 
> It has to move the manual directory manually because its installed in a
> non-FHS compliant directory. I could probably fix that using --mandir on
> the configure call instead.
> 
> Hamish

-- 
*********************************************
Paul Reich                Electrical Engineer

       Support the Freedom To Innovate
*********************************************