Re: gEDA-dev: Building pcb on cygwin from fresh CVS CO

[Peter Clifton <pcjc2-at-NOSPAMcam_dot_ac_dot_uk>]

On Thu, 2006-11-30 at 13:10 +0100, Timmerman, Bert wrote:
>  <<20061129_pcb-build.log.gz>> Hi all,
> 
> Last night I tried to configure/make pcb under cygwin from a fresh check
> out from cvs (not an update).
> 
> IMHO it is missing "puller.txt", "thermal.txt", "puller.png"and
> "thermal.png", complains about it and then bails out.

Try configuring with ./configure --with-gui=gtk --enable-maintainer-mode

Those files are auto-generated when PCB is built, and as such are not
checked into CVS. In a release tarball, they are shipped by whoever made
the tarball.

I've not done a build on cygwin myself though, but it should just work
if you have the right packages installed.

(IIRC, it only builds if there is an XServer running and DISPLAY is set
etc.. the program which generates some of the graphics does so using X.)

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-dev mailing list
geda-dev@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev